Video Assist for Aaton XTR (Reg16 or Super16)
The CCD image
sensor and video assist electronics are mounted inside the camera
body. The power necessary to supply the video assist is taken
internally from the camera's 4 pin XLR power input receptacle.
Specifications B&W:
- SONY CCD image sensor
- Signal system: EIA or
CCIR
- Picture elements:
512(H) x 492(V)(EIA)
- Scanning system: 2:1
Interlace
- Horizontal
resolution: 420 TV lines
- Min. illumination:
0.3 Lux (F/1.4)
- CCD IRIS control knob
- LED power indicator
- Power requirement:
12V DC (from the camera's battery)
- BNC video output
connector: 1.0 V p-p composite video at 75 ohm
- Power on/off switch -
3 position switch which controls the video power on/off
and AGC on/off
- Lower: Power is ON,
AGC is OFF, and the red LED is lit
- Middle: Power is OFF and the red LED is not lit
- Upper: Power is ON, AGC is ON, and the red LED is lit
- Power consumption:
1.4W (120mA/12V)
Specifications
for the color unit:
- SONY CCD image sensor
- Signal system: NTSC
or PAL
- Picture elements:
NTSC 768(H) x 494(V), PAL 752(H) x 582(V)
- Scanning system: NTSC
- 525 lines, PAL - 625 lines, 2:1 interlace
- Horizontal
resolution: 470 TV lines
- Min. illumination:
0.8 Lux, F1.2 AGC: ON
- BNC video output
connector: 1.0 V p-p composite video at 75 ohm
- White balance: AWB
(auto white balance)
- AGC/CCD IRIS control
switch: 3 position switch which
controls the CCD IRIS and AGC on/off
- Lower: AGC
control is OFF (0dB) and CCD IRIS control is OFF
- Middle: AGC control (max 14dB) is ON and CCD IRIS
control is OFF
- Upper: AGC control is OFF (0dB) and CCD IRIS control is
ON
- LED power indicator
- Power on/off switch: when in upper position, the video
power is ON and the red LED is lit; when in lower
position, the video power is OFF and the red LED is not
lit.
- Power requirement:
12V DC (from the camera's battery)
- Power consumption:
2.4 W (200mA/12V)
| HOME
| SERVICE
| E-MAIL
| PAYMENT OPTIONS
| WARRANTY |